slenderness

英 [ˈslɛndənəs]

美 [ˈslɛndərnəs]

网络  细长度; 长细比; 纤细; 名词; 细长

BNC.40473 / COCA.40756

英英释义

noun

• the property of an attractively thin person
  Synonym:slightnessslimness
• relatively small dimension through an object as opposed to its length or width
  1. the tenuity of a hair
  2. the thinness of a rope
  Synonym:thinnesstenuity
• the quality of being slight or inadequate
  1. he knew the slenderness of my wallet
  2. the slenderness of the chances that anything would be done
  3. the slenderness of the evidence

双语例句

• The calculation model of cable tension tested by frequency method for tied-arch bridge is analysed, the effects law of slenderness ratio on calculation precision are also analysed.
  对基于频率法测试系杆拱桥吊杆索力的计算模型的选用进行了研究，重点分析了吊杆长细比对模型计算精度的影响规律。
• It is shown that the nonlinear frequency ratio increases with the vibration amplitude and the slenderness ratio.
  计算结果表明非线性频率与线性频率之比随振动幅值的增大和梁长细比的增大而增大；
• The ground settlement can be manipulated by changing the pile slenderness ratio of blocked foundation with the pile below.
  采用下设桩基的块式基础，可通过改变桩的长径比来控制地基沉降。
• We try to combine slenderness with strength.
  我们力图将苗条和力量完美结合。
• Based on model experiment and simulated experiment, the formula of equivalent slenderness ratio was established.
  在模型试验和仿真试验的基础上，提出了单边连接高强角钢等效长细比公式。
• Combined with the proportion of length to width of tongue, the automatic quantitative analysis of plumpness and slenderness of tongues is realized.
  该文研究了曲线拟合参数与曲线形状胖瘦的关系，结合舌体的长宽比，实现了舌体胖瘦的自动定量分析。
• In this paper, the bearing capacity and failure modes of long angle steel truss concrete columns with different eccentricities and slenderness ratio are studied.
  本文对不同偏心距和长细比的内含角钢桁架混凝土长柱在偏心荷载作用下的承载力和破坏情况进行了研究。
• The results show that the most remarkable factor is the slenderness ratio, the axial compression ratio takes second place and the steel ratio is third.
  结果表明，对其影响最大的为长细比，其次是轴压比，再次是含钢率。
• This article presents a unified analysis of the limiting slenderness of plate elements of compression members with three commonly used sections.
  本文统一分析了轴心压杆三种常用截面的板件宽厚比限值。
• Volumetric efficiency, slenderness, span over length ratio increase with the cone angle.
  体积率、细长比和展长比都随着基本流场圆锥角的增大而增大。